Differential Cover, Rear, GM 10.5", 14 Bolt, Patterned Fins (3/8 inch Bolts), As-Cast

Volume: 1.0 qt. over stock

PML makes two different rear end covers for the GM 10½ differential: this one and a part number 6060, a straight fin cover.

This differential cover fits heavy duty trucks and vans such as Chevy and GMC 2500 and 3500.

Applications

Typical applications include the following. Be aware that for each model and year there may be more than one rear axle possible so please check before ordering. See also GM 14 bolt 9½ and AAM 14 bolt 11½.

¾ Ton Truck, 1973 to Current

C20 & K20

C2500 & K2500

Silverado 2500 & 2500HD

Sierra 2500 & 2500HD

1 Ton Truck, 1973 to Current

C30 & K30

C3500 & K3500

Silverado 3500 & Sierra 3500

¾Ton Van, 1973 to Current:

Vandura

Express

Savana

G20

G2500

Vehicle configurations vary. Please check dimensions, clearance and fitment carefully before ordering. There is a restocking fee for returns.

Vehicles with towing packages may have limited space for a larger differential cover. Also, the spare tire may be close to the cover. Some folks have increased the space by tying the spare tire back.

Bolts

This 14 bolt 10 1/2-inch differential cover uses 12 of the 14 bolts. The bolt hole at the bottom was removed because the drain boss is best located there. At the top of the cover another bolt hole was removed. The flange is 3/8-inch thick and blanchard ground to be flat and smooth. We have sold many of these and have never had a problem with leaking. The flange is very strong and the 2 bolts left out are not missed.

Please check and order the correct mounting bolt thread diameter. These differentials were made with 3/8-inch (.375 inch) and 8mm (.315 inch) bolts. PML offers the cover in both versions: P/N 9369-1 is for 3/8-inch bolts and P/N 9369-2 is for 8mm bolts.

Temperature Sending Unit Machining (OPTIONAL)

 PML GM 10.5 cover machined with 1/8 npt     Angle view PML GM 10.5 cover machined with 1/8 npt     Angle view PML GM 10.5 cover machined with 1/8 npt  

Optionally, this cover can be machined for a temperature sending unit. PML can drill and tap a 1/8 NPT hole on the front face. There is a $45 machining charge.

The hole is on the FACE of the cover. PML spot faces the area for a good seal. PML provides a plug for the hole.